***This kit is for Standard bed length only, it will not fit the Long Bed (8 foot). Email us ([email protected]) to get added to the Long bed waiting list we hope to add later in 2024****
Just because you have a lot of gear, doesn’t mean you have to have a lot of mess. While standard storage might not cut it, the BuiltRight Industries Bedside Rack System can. Using the same factory mounting points, the rack system installs to keep your gear organized, easily accessible and secure. They work with all MOLLE/PALS accessories in addition to universal slots for all kinds of storage possibilities. Proudly made in USA with a Lifetime Warranty.
Check out the videos below to see the process our engineering team used to design, prototype and test the HD MOLLE panel kit!
Engineering
In the 2020 GMC/Chevrolet HD lineup, each truck bed is equipped with three oval shaped holes in the bedside. Used along with the tie down loops near the front and rear, the Silverado and Sierra is very well equipped to support a full length MOLLE panel system. The BuiltRight Modular Bedside Rack System installs using these factory mounting points, without the need for modification to the vehicle. The panels provide MOLLE-compatible features for the use of MOLLE/PALS accessories in addition to universal slots for an infinite number of possibilities.
The Silverado and Sierra panels can be used as a 4pc kit, of course, but you can also order just one side or the other. This allows users to setup their truck as needed and add to their system if their gear mounting needs change.
- Store items that need to be easily accessible and organized
- Keep tools, straps, shackles, etc from rolling around in the bed of your truck
- Easily configured depending on intended use
- Made in USA. Lifetime Warranty.
Fitment:
- 2020 Chevrolet Silverado HD 6ft4in Bed
- 2020 GMC Sierra HD 6ft4in Bed
- Not compatible with Carbon Pro beds or 8ft bed YET
Kit Includes:
- All necessary panels
- Hardware kit w/ support brackets
Install
Installation is quick and easy. Remove the plastic covers plugging the oval shaped holes in the bed. Prepare the support brackets and tie down blocks and install them, snug but not fully tight. Install the rear panel and loosely bolt into place using tie down blocks. Loosely install the front panel in the same manner. Bolt the two panels together using the included stainless bolts. At this point, you may find that you need to adjust support brackets slightly front to back to accomodate desired fit. Tighten all hardware and you're done. Expect to spend 15-20min per side.
Kit includes all hardware necessary for installation. Users that have OEM Tie Down Anchors can choose to leave them in place instead of using the included hardware in some or all locations.
